32 Point Furnace Tune-up

32 Point Precision Furnace Tune-Up and Safety Inspection

• Clean and adjusting the furnace burner assemblage
• Clean furnace ignition assembly
• Check combustion air for carbon monoxide
• Test furnace starting capabilities
• Examine the heat exchanger for damage and/or corrosion
• Monitor the flue draft
• Test the furnace safety controls
• Inspect the gas piping
• Clean and/or replace standard air filters
• Measure for correct air flow
• Tighten electrical connections
• Measure volts and amps
• Lubricate all moving furnace parts
• Clean condensate drains
• Measure the temperature difference between supply air and return air
• Vacuum furnace return air compartment
• Adjust your gas pressure and your pilot
• Monitor the furnace’s heating cycle
• Clean the blower compartment
• Examine the furnace installation quality
• Examine equipment condition and clearance areas
• Check operation of combustion removal system
• Check limit switch operation
• Make sure pressure switch and tube are operating within specs
• Check flame sensor operation
• Check that burners ignition and flame within tolerance
• Balance blower wheel
• Test blower motor amperage
• Test of the high voltage regulator
• Check furnace to ducting connections for air leaks
• Inspect exhaust venting for safety
• Check Thermostat Calibration